Nut slot too low? The baking soda and superglue trick can really get you out of a hole pretty quickly. It’s best as a temporary repair but can sometimes work longer term too.
Check it out…
Read More
Paper or cardboard is usually a terrible, tone-sucking material to use as a shim. Unless you learn this one cool trick that Big Nut doesn’t want you to know. You won’t believe what happens next! 😉
Nah, seriously… It’s good.
Read MoreA nut with a low slot (or slots) is a pain. It buzzes when you play the open string and sounds generally awful. You could replace it with a nice new nut but, sometimes you’re in a hurry or on a budget.
Enter the shim…
Read More
Can you reverse a shim to give your guitar a forward neck angle? Should you do this? Is there a benefit. Are some builders using this secret trick to improve their guitars?
Read More
Why do some guitars have necks that angle back towards the player while some don’t? What’s the reason for this angled neck? Do we even need it?
Read More
Applying your own logo or design to your build or parts-caster feels fantastic. And it’s not so difficult. Say hello to the water-slide decal.
Read more…
Read More
WE’ve looked a some methods to remove a worn or broken screw. These have mostly involved gripping the screw in some way to try unscrew it from the guitar. But what if there’s just no way to grip the screw? What’s the thing we leave until the very end to try?
Check it out…
Read More
If there’s just no grip left on the screw, it might be necessary to drill out its head in order to remove whatever it’s holding in place (a pickguard or tuner for instance). Learn how to drill worn or stripped screw heads for removal.
Check it out…
Read More
Screws can get worn, corroded, and crammed with crud over the years. Removal can become challenging. Here’s the first in a series of posts with tips for removing stubborn screws.
Check it out…
Read More
Word has been going around the internet recently about a cheap alternative to gauged nut files for guitar and bass. Since a proper set of nut files isn’t cheap, this is tempting. But is this alternative any good?
Read More
Installing a pre-cut/pre-shaped nut requires a lot of patience to do well. It’s easy to hack off some bits and glue it in but, doing it well and getting a good setup… that takes time and some Buddha-like levels of patience.
Most of the nut manufacturers don’t tell you that. Go figure.
Check out how to get a great result…
Read More
Installing a pre-cut/pre-shaped nut starts with measuring your existing nut to ensure you choose one that’s right for the job. Most of the measurements are obvious and are those that the nut manufacturers recommend in their own documentation. But… There’s one they rarely mention. And it’s important.
Check it out…
Read More