Applying your own logo or design to your build or parts-caster feels fantastic. And it’s not so difficult. Say hello to the water-slide decal.
Read more…
Read MoreApplying your own logo or design to your build or parts-caster feels fantastic. And it’s not so difficult. Say hello to the water-slide decal.
Read more…
Read MoreWE’ve looked a some methods to remove a worn or broken screw. These have mostly involved gripping the screw in some way to try unscrew it from the guitar. But what if there’s just no way to grip the screw? What’s the thing we leave until the very end to try?
Check it out…
Read MoreIf there’s just no grip left on the screw, it might be necessary to drill out its head in order to remove whatever it’s holding in place (a pickguard or tuner for instance). Learn how to drill worn or stripped screw heads for removal.
Check it out…
Read MoreScrews can get worn, corroded, and crammed with crud over the years. Removal can become challenging. Here’s the first in a series of posts with tips for removing stubborn screws.
Check it out…
Read MoreWord has been going around the internet recently about a cheap alternative to gauged nut files for guitar and bass. Since a proper set of nut files isn’t cheap, this is tempting. But is this alternative any good?
Read MoreInstalling a pre-cut/pre-shaped nut requires a lot of patience to do well. It’s easy to hack off some bits and glue it in but, doing it well and getting a good setup… that takes time and some Buddha-like levels of patience.
Most of the nut manufacturers don’t tell you that. Go figure.
Check out how to get a great result…
Read MoreInstalling a pre-cut/pre-shaped nut starts with measuring your existing nut to ensure you choose one that’s right for the job. Most of the measurements are obvious and are those that the nut manufacturers recommend in their own documentation. But… There’s one they rarely mention. And it’s important.
Check it out…
Read MoreFender nuts usually have an arc along their bottom. This mates with a similar curve in the nut slot itself. If you’re installing a new nut, you’ll have to match this radius closely for a good fit.
Find out how…
Read MoreI’ve often hammered home the idea that players need to understand that a guitar needs to the setup for their style to prevent fret buzz. ‘As low as it can go’ isn’t as simple as it sounds and the player plays a massive part in whether a guitar buzzes.
But sometimes the guitar is to blame. And I should talk about that too…
Read MoreAnswering questions about the clever fix made to address limitations around replacing the zero fret on Brian May’s famous Red Special guitar. Great thinking…
Read MoreA while back, I wrote about some methods for enlarging holes — for instance, if you wanted to fit larger tuners or a larger control pot into a hole that had housed something smaller.
But what if you want to go the other way? What if you want to remove some hardware that’s bigger than the stuff being installed?
Read MoreGuitar and bass neck sometimes get ski jump deformations. Turns out it’s important how you define your ski jump. Avoid confusion and check this out…
Read More